All new, every-day, step-down, performance player, developed with Kolohe Andino. The 3.0 STUB DRIVER is a direct derivative of the long time developed, but recently released, DRIVER 3.0, designed with elite level surfers looking for the “Ultimate Driving Machine”. Primarily tested in and around the waves of the World Tour (not necessarily the typical 1’-3’ soft slop that most of us suffer through daily), the DRIVER3.0 still left room at the lower end for higher performance in lesser waves. Enter the 3.0 STUB DRIVER, a stepped-down and “stubbed”, low end/high performance, smaller wave-ripping machine. Unlike the Sub-Drivers (our other step-down performance boards) the 3.0 STUB DRIVER does not use any vee in the tail. Instead, it features a continuous rocker/concave combination. This is the primary difference between the two. While noticeably relaxed from DRIVER3.0 rocker, it is still loose and lively, quick and easy to release, under the rear foot. Fitting more effortlessly into small pockets or quick dumpy sections than the Sub Drivers. Perfect for small beach break. The similarities in rocker, bottom contours and outline, maintain a closer feel, when switching between the DRIVER3.0 and 3.0 STUB DRIVER. That was the goal and that is the result. Working with Kolohe, who after riding DRIVER3.0 in proper surf, wanted to feel like he was riding the same board out at T-Street, or small Trestles. Riding SubDrivers “felt almost stiff”, so he wanted a board that required no adjustment to technique and could swapped seamlessly back and forth with the DRIVER3.0. “Why not just make a step-down board off of that?” If you’re passionate about performance surfing, riding performance surfboards...and tend to do so in average to sub-par surf, then the 3.0 STUB DRIVER is for you. Designed to be ridden just 1” shorter than a DRIVER3.0 and our stock dims reflect that. If you ride a 6’0” DRIVER3.0, the 5’11” 3.0 STUB DRIVER should slide in perfectly. Together they make for a perfectly paired duo of modern, high performance vehicles. Features: [When compared to the DRIVER3.0] Relaxed entry rocker, with a slightly wider nose area. Relaxed tail rocker, with a slight hip and wider tail block (but not as wide as the SubDrivers). More width overall, with thickness carried further into the nose and under the rear foot. Deeper single and double concave combination, for more lift, with plenty of rail curve, in lesser surf. Slightly flatter deck, with soft, forgiving rails.
All new, every-day, step-down, performance player, developed with Kolohe Andino. The 3.0 STUB DRIVER is a direct derivative of the long time developed, but recently released, DRIVER 3.0, designed with elite level surfers looking for the “Ultimate Driving Machine”. Primarily tested in and around the waves of the World Tour (not necessarily the typical 1’-3’ soft slop that most of us suffer through daily), the DRIVER3.0 still left room at the lower end for higher performance in lesser waves. Enter the 3.0 STUB DRIVER, a stepped-down and “stubbed”, low end/high performance, smaller wave-ripping machine. Unlike the Sub-Drivers (our other step-down performance boards) the 3.0 STUB DRIVER does not use any vee in the tail. Instead, it features a continuous rocker/concave combination. This is the primary difference between the two. While noticeably relaxed from DRIVER3.0 rocker, it is still loose and lively, quick and easy to release, under the rear foot. Fitting more effortlessly into small pockets or quick dumpy sections than the Sub Drivers. Perfect for small beach break. The similarities in rocker, bottom contours and outline, maintain a closer feel, when switching between the DRIVER3.0 and 3.0 STUB DRIVER. That was the goal and that is the result. Working with Kolohe, who after riding DRIVER3.0 in proper surf, wanted to feel like he was riding the same board out at T-Street, or small Trestles. Riding SubDrivers “felt almost stiff”, so he wanted a board that required no adjustment to technique and could swapped seamlessly back and forth with the DRIVER3.0. “Why not just make a step-down board off of that?” If you’re passionate about performance surfing, riding performance surfboards...and tend to do so in average to sub-par surf, then the 3.0 STUB DRIVER is for you. Designed to be ridden just 1” shorter than a DRIVER3.0 and our stock dims reflect that. If you ride a 6’0” DRIVER3.0, the 5’11” 3.0 STUB DRIVER should slide in perfectly. Together they make for a perfectly paired duo of modern, high performance vehicles. Features: [When compared to the DRIVER3.0] Relaxed entry rocker, with a slightly wider nose area. Relaxed tail rocker, with a slight hip and wider tail block (but not as wide as the SubDrivers). More width overall, with thickness carried further into the nose and under the rear foot. Deeper single and double concave combination, for more lift, with plenty of rail curve, in lesser surf. Slightly flatter deck, with soft, forgiving rails.
in 2 offers
All new, every-day, step-down, performance player, developed with Kolohe Andino. The 3.0 STUB DRIVER is a direct derivative of the long time developed, but recently released, DRIVER 3.0, designed with elite level surfers looking for the “Ultimate Driving Machine”. Primarily tested in and around the waves of the World Tour (not necessarily the typical 1’-3’ soft slop that most of us suffer through daily), the DRIVER3.0 still left room at the lower end for higher performance in lesser waves. Enter the 3.0 STUB DRIVER, a stepped-down and “stubbed”, low end/high performance, smaller wave-ripping machine. Unlike the Sub-Drivers (our other step-down performance boards) the 3.0 STUB DRIVER does not use any vee in the tail. Instead, it features a continuous rocker/concave combination. This is the primary difference between the two. While noticeably relaxed from DRIVER3.0 rocker, it is still loose and lively, quick and easy to release, under the rear foot. Fitting more effortlessly into small pockets or quick dumpy sections than the Sub Drivers. Perfect for small beach break. The similarities in rocker, bottom contours and outline, maintain a closer feel, when switching between the DRIVER3.0 and 3.0 STUB DRIVER. That was the goal and that is the result. Working with Kolohe, who after riding DRIVER3.0 in proper surf, wanted to feel like he was riding the same board out at T-Street, or small Trestles. Riding SubDrivers “felt almost stiff”, so he wanted a board that required no adjustment to technique and could swapped seamlessly back and forth with the DRIVER3.0. “Why not just make a step-down board off of that?” If you’re passionate about performance surfing, riding performance surfboards...and tend to do so in average to sub-par surf, then the 3.0 STUB DRIVER is for you. Designed to be ridden just 1” shorter than a DRIVER3.0 and our stock dims reflect that. If you ride a 6’0” DRIVER3.0, the 5’11” 3.0 STUB DRIVER should slide in perfectly. Together they make for a perfectly paired duo of modern, high performance vehicles. Features: [When compared to the DRIVER3.0] Relaxed entry rocker, with a slightly wider nose area. Relaxed tail rocker, with a slight hip and wider tail block (but not as wide as the SubDrivers). More width overall, with thickness carried further into the nose and under the rear foot. Deeper single and double concave combination, for more lift, with plenty of rail curve, in lesser surf. Slightly flatter deck, with soft, forgiving rails.
All new, every-day, step-down, performance player, developed with Kolohe Andino. The 3.0 STUB DRIVER is a direct derivative of the long time developed, but recently released, DRIVER 3.0, designed with elite level surfers looking for the “Ultimate Driving Machine”. Primarily tested in and around the waves of the World Tour (not necessarily the typical 1’-3’ soft slop that most of us suffer through daily), the DRIVER3.0 still left room at the lower end for higher performance in lesser waves. Enter the 3.0 STUB DRIVER, a stepped-down and “stubbed”, low end/high performance, smaller wave-ripping machine. Unlike the Sub-Drivers (our other step-down performance boards) the 3.0 STUB DRIVER does not use any vee in the tail. Instead, it features a continuous rocker/concave combination. This is the primary difference between the two. While noticeably relaxed from DRIVER3.0 rocker, it is still loose and lively, quick and easy to release, under the rear foot. Fitting more effortlessly into small pockets or quick dumpy sections than the Sub Drivers. Perfect for small beach break. The similarities in rocker, bottom contours and outline, maintain a closer feel, when switching between the DRIVER3.0 and 3.0 STUB DRIVER. That was the goal and that is the result. Working with Kolohe, who after riding DRIVER3.0 in proper surf, wanted to feel like he was riding the same board out at T-Street, or small Trestles. Riding SubDrivers “felt almost stiff”, so he wanted a board that required no adjustment to technique and could swapped seamlessly back and forth with the DRIVER3.0. “Why not just make a step-down board off of that?” If you’re passionate about performance surfing, riding performance surfboards...and tend to do so in average to sub-par surf, then the 3.0 STUB DRIVER is for you. Designed to be ridden just 1” shorter than a DRIVER3.0 and our stock dims reflect that. If you ride a 6’0” DRIVER3.0, the 5’11” 3.0 STUB DRIVER should slide in perfectly. Together they make for a perfectly paired duo of modern, high performance vehicles. Features: [When compared to the DRIVER3.0] Relaxed entry rocker, with a slightly wider nose area. Relaxed tail rocker, with a slight hip and wider tail block (but not as wide as the SubDrivers). More width overall, with thickness carried further into the nose and under the rear foot. Deeper single and double concave combination, for more lift, with plenty of rail curve, in lesser surf. Slightly flatter deck, with soft, forgiving rails.
Last updated at 09/09/2025 04:02:42
