Description Mold remover For rubber packing Body 100g x 1 Since it is a gel type, it is a mold remover that adheres to the mold on the rubber packing and removes it cleanly. Because it is a gel type, the liquid does not drip and adheres to mold. Pen type that can be applied pinpointly even in small places. For removing mold from rubber packing for bathrooms, rubber packing for doors, and tile joints. Can also be used for window frames that cause condensation. * Please read the precautions carefully before use. Be careful not to get the gel in your eyes or on your skin as it may irritate your eyes and skin. Always use alone. Hazardous gas is generated when mixed with acidic type products, vinegar, alcohol, ammonia, etc. Do not use above the line of sight. Do not use for anything other than its intended purpose. Foreign-made tiles and unit baths may discolor, so be sure to try them in an inconspicuous place before using them. If the liquid adheres to the bathtub, wall, or sash, it may discolor, so wash it off immediately with water without leaving it. Be careful as it will decolorize when it gets on clothing or rugs. Do not transfer to another container for use. Do not drop to avoid damage. Do not place in contact with children or pets. How to use: 1. Remove the cap and apply directly to the dirty area.Apply directly to the dirty area and leave for 15-30 minutes. * While pressing the bottle lightly, adjust the amount of liquid that comes out. Note that if you press it too hard, the liquid may splash out. 2. Remove with a water wipe.When the mold stains are removed, wipe it thoroughly with a rag. * Please do not use wet tissues.