ARB CKMA12 Air Compressor High Output On-board 12V Air Compressor

Bought and installed this about a year ago. ( I still need to mount the air hose externally so I don’t have to open the hood each time I need to access) installation of the unit was pretty straightforward and easy to follow, The old Jack mount in my engine compartment was a great spot for me to just install on a flat surface. The unit itself can be altered and adjusted to fit pretty much anywhere. For me, this unit is working out great, I only need it on occasions where I don’t have access tour outside compressor. Fills my 33 inch tires up in about 1 to 3 minutes each depending on how low I dropped my air pressure. The unit does get very HOT when I have to use it for long periods of time. (if I needed this unit every time I went wheeling I would definitely get the ... MoreBought and installed this about a year ago. ( I still need to mount the air hose externally so I don’t have to open the hood each time I need to access) installation of the unit was pretty straightforward and easy to follow, The old Jack mount in my engine compartment was a great spot for me to just install on a flat surface. The unit itself can be altered and adjusted to fit pretty much anywhere. For me, this unit is working out great, I only need it on occasions where I don’t have access tour outside compressor. Fills my 33 inch tires up in about 1 to 3 minutes each depending on how low I dropped my air pressure. The unit does get very HOT when I have to use it for long periods of time. (if I needed this unit every time I went wheeling I would definitely get the twin) great unit, and I’m definitely not disappointed I bought it.

Just installed this in a Jeep TJ. I took the time to locate it under the brake booster as this is like an unused area and would be a good place for it. Was going to run wires and run it thru the Rough Country MLC-6 switch pod, but the ARB harness is kind of small and is already set up for the pressure switch and solenoids I decided to use it instead of running my own wires. After I installed the compressor I then ran the wire harness to the switches in the switch pod and battery. Compressor works good, kind of hard to find air leaks for the noise, but I used a soap/water to find 'em and of course all the leaks were on the manifold for the solenoids. Tightened those up and works fine. Cycles off/on every few minutes, will probably add a little larger tank and mount ... MoreJust installed this in a Jeep TJ. I took the time to locate it under the brake booster as this is like an unused area and would be a good place for it. Was going to run wires and run it thru the Rough Country MLC-6 switch pod, but the ARB harness is kind of small and is already set up for the pressure switch and solenoids I decided to use it instead of running my own wires. After I installed the compressor I then ran the wire harness to the switches in the switch pod and battery. Compressor works good, kind of hard to find air leaks for the noise, but I used a soap/water to find 'em and of course all the leaks were on the manifold for the solenoids. Tightened those up and works fine. Cycles off/on every few minutes, will probably add a little larger tank and mount on my skid plate to increase capacity and hopefully reduce run time.

I installed this little compressor in my 2000 TJ for airing up 35 inch tires after off road driving. This is the fastest compressor I have ever used, airing up 4 35s in a few minutes. I highly recommend this compressor for it's reliability and compact nature.