G.SKILL F4-3600C16D-32GTZNC Trident Z Neo RGB 32GB 3600MHz DDR4

I bought this RAM after I had disappointing results with the older one I was using (Corsair Vengeance LPX 3200). This GSkill ram is not only faster at 3600 Mhz, its also very stable. I installed it on an ASUS ROG Crosshair Hero VIII motherboard paired with the AMD 3950X and this is a beast! Very stable for the last few months and my Cinebench scores went up e to the faster speed. To enable 3600 Mhz, make sure you go to the BIOS and AMD settings and enable DOCP (Direct Over Clock Profile). This works much better than XMP.Now when it comes to aesthetics, this RAM is beautiful with the RGB lighting. The only con I can think of is that the top part of the RAM is extremely sharp. So I was a little scared putting it in the slots. It does look good but its sharp to the ... MoreI bought this RAM after I had disappointing results with the older one I was using (Corsair Vengeance LPX 3200). This GSkill ram is not only faster at 3600 Mhz, its also very stable. I installed it on an ASUS ROG Crosshair Hero VIII motherboard paired with the AMD 3950X and this is a beast! Very stable for the last few months and my Cinebench scores went up e to the faster speed. To enable 3600 Mhz, make sure you go to the BIOS and AMD settings and enable DOCP (Direct Over Clock Profile). This works much better than XMP.Now when it comes to aesthetics, this RAM is beautiful with the RGB lighting. The only con I can think of is that the top part of the RAM is extremely sharp. So I was a little scared putting it in the slots. It does look good but its sharp to the point where you can use it as a knife (no kidding).But overall I recommend this RAM due to its speed and cost and thanks to Microcenter for always having parts stocked and within arms reach!

Good RAM, especially for a Ryzen system. I’m currently using it for a new Intel build though. It’s not 16-16-16-36 B-die (which Gskill also sells for $40 more) but it is still low latency CL16 RAM and more than satisfactory if you aren’t doing extreme overclocking. Never was a huge fan of RGB memory to begin with, but I’d figure I would jump on the bandwagon. It looks pretty good, although the LEDs could transition a bit smoother. And watch out for the sharp edges on the heat spreaders.

Parting together a new PC to replace my old i7-4790k system. CL16 3600 is considered a pretty good sweet spot for Ryzen 5000 series, so getting a set on a pretty good discount was nice.Like the dual tone look, and RGB customizability is a first coming from middling DDR3 sticks.sticks run at rated speeds in testing without any instability. It does what it says it does, that pretty much says it all.